Metrohm IC Net 2.0 Uživatelský manuál stáhnout pdf (Strana 84)

6 Devices

IC Net 2.0

Second column Program instruction (see below).

Third column Parameter for program instruction (see

below).

ENABLED Enable program start (a disabled program

is not started).

<Add> Add new program instruction.

<Delete> Delete selected program instruction.

<Verify> Test the time program (error messages are

displayed if program is wrong).

List of program instructions

The following program instructions can be added to the time pro-

gram on the Program page:

Instruction Parameter entry Meaning

Program RESET, END Set program flag. The END flag

can be used to end a program,

especially if the program time

should be longer than the chro-

matogram duration. Additional

steps after this flag are not al-

lowed. The RESET flag is used to

reset the parameters to the sys-

tem startup values.

Pump on, off Switch on or off the pump drive.

Links

The Links tab of the 752 Pump Unit is used for COM port selection

and settings (details see section 5.2.4).

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 195 196

Žádné komentáře

Metrohm IC Net 2.0 Uživatelský manuál Strana 84